Annotation: Today, the basis of a successful economy is the full development of all its sectors, the priority of which is the real sector. At the same time, historically, the trends in the development of the real sector of the economy imply the inevitable cyclical nature of the processes taking place in it, affecting, first of all, the activities of its economic entities. Crisis phenomena periodically bring industrial enterprises out of equilibrium. The scale of these phenomena can reach such dimensions that their elimination is not amenable to management decisions, since the effectiveness of the latter can be achieved only at the early stages of crisis phenomena. In modern realities, an effective anti-crisis management system at manufacturing enterprises is an important component of solving strategic problems. Acceleration of the processes of rehabilitation of the post-crisis state of the enterprise requires the development of methods of the most effective levers of anti-crisis management at manufacturing enterprises. In this regard, it is important to determine the key principles and approaches to the formation of anti-crisis management mechanisms. In the scientific environment, when studying anti-crisis management, the institutional component is rarely considered, although recently it has been coming to the fore in terms of the impact on the development of the enterprise. The purpose of the article is to consider the concepts of "institutionalism", "institutional environment" in the framework of crisis management of enterprises, to reveal the organizational and economic mechanism of crisis management of manufacturing enterprises. When writing the article, a systematic approach was used using such general scientific methods as analysis and synthesis, a combination of historical and logical, the method of system analysis The result is the identification of the main problems related to the anti-crisis management of the enterprise, taking into account the institutional component, as well as the offer of tools to prevent crisis situations or reduce the negative consequences of an existing crisis

Annotation: The banking system is one of the most important components of the economy of any state, ensuring the functioning of the economy. The researchers study the functioning of individual banks and the banking system as a whole, because it is the banking system being an intermediary in the market system of relationships that allows financing of all spheres and branches of the national economy and the organization of their interaction. In modern conditions of aggravation of the economic crisis, pandemic, the role and importance of second-tier banks is changing. Banks, being one of the most dynamic and «flexible» spheres of economic activity, not only organize the functioning of economic entities, but also face a number of «newly created» problems that were not discussed until recently: cybercrime, data leakage, various modified fraudulent schemes and much more. An important distinguishing feature of the banking system is its dynamism, the ability to quickly respond to changes in the economy, the challenges of globalization. The domestic banking system copes quite well with the challenges of globalization, which is highlighted in this study. The purpose of the article is to consider the changes taking place in the banking system of Kazakhstan in modern conditions. When writing the article, methods of comparison, analysis, synthesis, aggregation, etc. were used. The result is the identification of the main problems related to the current state of the banking system, as well as their impact on the future configuration, improvement of the banking system, can be useful to bank employees dealing with the management of the banking system.

Annotation: Main problem: In modern science, there are a large number of techniques focused on the assessment of competitiveness through the analysis of certain resources in the region. However, accounting of human resources in such assessments is not used as a prior factor in identifying regional competitive advantages. Competitive advantages affect not only the efficiency of individual sectors of the economy but also the overall social and economic development of the country. Evaluation of the competitiveness of the region should include one of the main parameters of the human resource and economic development level. Therefore, the forecast for the competitiveness of the region should take into account the pace of human resources development. Purpose of the research is evaluation of regions’ competitiveness as the main parameter of economic development in current conditions. Methods: The methods used in Kazakhstan for assessing the competitiveness of a region considers only the assessment of human resources in its structure but do not take into account the level of their development over time, as well as the multi-factorial nature of their components. Results and their value: The work explains and analyzes rating model for assessing of the competitiveness of the regions of Kazakhstan (the National Chamber of Entrepreneurs of the Republic of Kazakhstan). The authors proposed a methodology for ranking the regions of Kazakhstan based on an assessment of the development of their human resources that affect the competitiveness of the region. It includes an analysis of demographic, labor and social and economic indicators reflecting the state of human resources.

Annotation: The article presents a method of teaching object-oriented programming to students of the educational program «Computer Engineering and software» using the project method. The problem of the insufficient level of organization of the educational process in colleges, aimed at studying any kind of object programming, is investigated. In this regard, the important aspects that must be taken into account when constructing a methodology for teaching object-oriented programming, aimed at enhancing the cognitive independence of students, are described in detail. It is shown that the solution to this problem largely depends on the degree of achievement of the learning goals of students specified in GOSTiPO, as well as on the methodological guide to object-oriented programming, developed in accordance with the requirements of modern education. An analysis was made of the State Compulsory Standard for Technical and Vocational Education of the Republic of Kazakhstan, the Model Curriculum and the Working Curriculum in the discipline "Fundamentals of Object-Oriented Programming" for students of the educational program "Computer Engineering and Software" and the teaching methodology developed on their basis. The purpose is to substantiate the methodology for teaching students object-oriented programming, which activates cognitive activity through the use of the project method and its practical application in the educational process. Methods: The methods of analysis, synthesis and deduction were used in the article. Results and their significance: The practical result of the analysis was the method of teaching college students object-oriented programming, using the project method, which is necessary for a more intensive development of cognitive independence. The practical significance of the results is to increase the efficiency of studying the discipline by taking into account the individual characteristics of students.

Annotation: Main problem: Bird droppings and animal manure contain acids, nitrogen, phosphorus and potassium, heavy metals. The content of nitrogen, phosphorus and potassium changes dramatically depending on the quantity and quality of the feed. Purpose: To study the effectiveness of the use of organomineral fertilizer from poultry waste, obtained using biocatalytic processes on the growth and development of plants. Methods: An application for a Patent for the invention of the Republic of Kazakhstan "Method of obtaining organic fertilizer" has been submitted for the developed technology for obtaining organic-mineral fertilizer. In the soil intended for growing seedlings of tomatoes of the “Pepper-shaped Orange” variety and peppers of the “Bogatyr” variety, the resulting fertilizer was applied in the amount of 1 kg per 1 m2 of soil, which was dug to a depth of 8-10 cm and used to grow seedlings in closed ground and subsequent for planting it in open ground. Soil without fertilization was used as a control. The process of soil preparation for open ground, intended for planting seedlings, was carried out for the experimental field with the introduction and control without fertilization. Experimental and control studies were carried out under equivalent climatic conditions, the scheme and technology of watering plants. In total, 100 bushes of each plant species were used in the experiment. Results and their significance: The use of the obtained organomineral fertilizer allows to increase the yield of vegetable crops (tomatoes, peppers) by 20-25% compared to the control. In addition, in the experimental samples, an increase in the number of fruits on a bush was noted with an increase in their size, a decrease in the growing season and the number of damaged fruits.

Annotation: Main problem: The use of waste heat is most often solved by installing heat exchangers, but this is not effective when the temperature of this heat does not exceed 10-15 0 C, in which case this heat can be used using a heat pump. Where can I get this heat? Almost any enterprise needs cooling of any equipment elements or substances – working fluids; the heat received from them can be sent to a heat pump and used here at the enterprise. Purpose: Consideration of the possibility of using the heat of cooling water from the pump CNS 60-165 and the proposal of a new scheme with the installation of a heat pump that uses this heat. Methods: This is achieved due to the fact that it is proposed not to discard the heat, but after its use in the heat pump evaporator, transfer it to the heated medium - water, which is then sent to the shower cabins of the enterprise. Since the showers are located in the same room, the cost of transporting heat and losses will be minimal. Methods: In the course of the research, the possibility of using the waste heat of an industrial enterprise for using it here at the enterprise for the purposes of hot water supply was considered. For these purposes, it is proposed to install a heat pump, thanks to which the thermal potential increases, which makes it possible to fully use the received heat. Results and their significance: As the experience of foreign countries has shown, heat pumps can be widely used in many industrial enterprises, and in conditions of increased competitiveness, in order to reduce energy costs and the cost of manufactured products, install heat pumps to utilize excess heat, for example, process water, which is available in many production allows you to have a significant economic effect.

Annotation: Main problem: Today electronic information is one of the important resources in the management system. Electronic information resources are not only means, but also control flows. For example, any instruction or instruction in the management system is actually a guide to action. At the same time, for example, data on the movement of an object (employees, goods, money, etc.) are information resources, the storage and accounting of which is the basis of the organizational process. Large flows of information require their structuring, and operations on them become time-consuming. One of the ways to solve this problem is the development and implementation of an information system. Purpose: To analyze and design an information system using specialized tools designed to optimize the implementation of the above stages of software system development, using the example of a real business process. Methods: The article discusses the methodologies of CASE tools designed to automate software development processes, namely, the first two stages of the life cycle: analysis and design of a software product. The analysis and design of the business process functionality is carried out using the IDEF0 functional modeling methodology. The design of the database structure of the information system was carried out using the methodology of semantic (information) modeling IDEF1X. Description of the scenario of the designed software for a real business process is carried out using the dynamic modeling methodology IDEF3. Results and their significance: The article substantiates the relevance of the use of modern CASE-technologies in the process of analyzing and designing a future information system, as well as for the purpose of possible optimization on the example of a real business process "Inventory accounting". As a result, a comprehensive business process model was built using tools based on CASE-methodologies. The resulting model, as well as the description of its construction, is a clear example of the use of CASE technologies for software developers, as well as system analysts and IT specialists.

Annotation: The paper considers two data-driven methods for anaphora resolution of Kazakh texts. These methods are based on machine learning with annotated corpora and using no additional information except linguistic features. The first method uses Support Vector Machine as learning and classifying algorithms, the second method uses Decision Tree inducer. We evaluate the performance of the methods with several feature sets and corpora. Feature sets included morphological, syntactic, and semantic features. In this paper We also evaluate how semantic features, namely semantic roles, impact the performance of anaphora resolution in Kazakh language. Experiments showed that precision of SVM is higher on experimental data for almost all cases. It was shown that semantic features enhance the performance of the methods for anaphora resolution of Kazakh texts. We have also calculated the optimal distance between the anaphor and the hypothetic antecedent and used it in our methods.

Annotation: An analysis of the mechanical, chemical and pyrogenic impact of the Baikonur Cosmodrome on the environment showed the presence of man-made impacts of the first stages (FS) used on the ecosystems of the impact zones (IZ). This article presents the concept of a controlled landing of spent launch vehicles with liquid rocket engines (LRE) in the expected zones of damage to the ecosystems of the area while maintaining the energy-optimal launch scenario of the launch vehicle. Purpose of the article - development of effective technologies for reducing the anthropogenic impact during launches of promising rockets from the Baikonur Cosmodrome based on theoretical and experimental studies of innovative technologies: reducing the area of impact of parts from launch vehicles; fire and explosion safety, no danger of rocket launchers; controlled descent of used first stages; To solve the problem, it is proposed to create an additional IASM, which will be included in the environmental management system of the Baikonur Cosmodrome. Possible design solutions are proposed based on the evaporation of untreated liquid waste from the tanks of separated parts, their fire and explosion safety, and the use of the obtained vapor-gas mixtures for controlled unloading of separated parts while moving along the landing trajectory to the optimal area. The authors of the article have developed evaluation criteria that characterize the main environmental indicators of the studied areas: fire hazard, soil cover and impact on vegetation are studied for inclusion in the IASM. There are objective requirements and basic rules for the creation of HIASM, which is an integral part of the environmental management system of the cosmodrome.

Annotation: Local self-government bodies are an integral mechanism of the foundation of a democratic state. In the modern system of public relations, one of the most important places is occupied by general economic relations, namely local self-government. Without a developed system of local self-government, legislative and real opportunities, it is very difficult to independently create market-democratic structures to solve economic, social, domestic, cultural and other issues at the local level. Local self-government bodies are a special level of government, which combines two principles: public and state. In the practice of Constitutional and administrative law, it is important to determine the place and nature of local self-government and to establish balanced relations between State authorities and self-government bodies, on the one hand, with local representative offices and structures. The purpose of the article isto study the role and place of local self-government in modern society, to develop practical recommendations on the formation and prospects for the development of local authorities in Kazakhstan. When writing an article, the following methods are used: description, analysis and synthesis, justification, logical modeling, system analysis, etc. When studying the formation of local self-government, as well as the functional management system, the method of structural and analytical analysis was used. The conclusions and recommendations obtained as a result of the conducted research can be used: in the practical activities of maslikhats and akimats of the Republic of Kazakhstan, civil servants; in the process of studying at courses in higher educational institutions, as well as for further general theoretical and applied research.